Burkert FLOWave L - Deactivating the Monitoring of the Liquid Concentration

184
SAW sensor – Parameter
Type 8098 FLOWave L
→ Concentration1 or Concentration2
→ Limits
→ Active
→ Yes.
→ 
The monitoring of the liquid concentration is active and the device status will change depending on the
limits that have been set.
→ 
.
→ 
.
→ To enable the monitoring, i.e. to be informed when the value of the liquid concentration is outside the
.
15.7.7 Deactivating the monitoring of the liquid concentration
By default, the liquid concentration values are not monitored. If the monitoring of a liquid concentration
value is active, do the following to deactivate it:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values
→ Concentration1 or Concentration2
→ Limits
→ Active
→ No
→ 
The monitoring of the liquid concentration is inactive.
English