Burkert FLOWave L - Choosing the Damping Level of the Values Transmitted on an Analogue Output

290
Outputs – Parameter
Type 8098 FLOWave L
18.3.2 Choosing the damping level of the values transmitted on an
analogue output


The set damping level for the volume

)
The resulting volume

The set damping level for the ana-
logue outputs is applied

The calculated volume
is used by the totalizers
and the pulse outputs.

is transmitted on the analogue
outputs
 
When the damping is active (i.e. when a Low, Medium or High level has been set) and the values

applied to the new measured value.
 
Damping level Response time
None 
 
 
 
English