Burkert FLOWave L - Message Do2 Overload Or Do3 Overload; Message No Proper Connection To The Process Control System; Messages Due To The Industrial Communication Module

345
Maintenance and troubleshooting
Type 8098 FLOWave L
24.12.12 Message "DO2 overload" or "DO3 overload"
Message DO2 overload
or
DO3 overload
Symboldisplayedinthe
informationbar
Depends on the device status the event is associated to.
Possiblecause
An overload has been detected at the related digital output. A current higher

The output has switched.
-
toring special events that occur in the process, on the sensor or on the
electronics.
Whattodo?
→ 
→ 

24.13 Messages due to the industrial communication
module
24.13.1 Message "No proper connection to the process control
system"
Message
No proper connection to the process control system
Symboldisplayedinthe
informationbar
Possiblecause There is no physical connection between the device and the control unit

control unit.
Whattodo?
→ 
→ 
device and at the control unit (e.g. IP address).
English