322
Maintenance and troubleshooting
Type 8098 FLOWave L
→ Rinse the measurement tube with water of the best quality available in the factory (ideally, water for
→ If needed, let a second cleaning agent circulate through the measurement tube, under the same condi-
→
→ Blow air through the measurement tube to remove moisture and to ensure maintenance of a good
passive layer.
→
3
-
→
3
as the CIP-procedure. Then, rinse the measurement tube with water with the best quality available in the
→ Blow air through the measurement tube to remove moisture and to ensure creation of a uniform passive
layer.
24.5 Sterilisation In Place (SIP) of the device
The measurement tube of the device can be sterilised in place in all the applications the device is used in.
→
English
To Next Page
Loading...
