Burkert FLOWave L - Enabling The Diagnostics For Special Events Occurring On The Sensor

240
SAW sensor – Parameter
Type 8098 FLOWave L
15.14.6 Enabling the diagnostics for special events occurring on the
sensor
By default, all the diagnostics related to the sensor are disabled.
To enable the diagnostics related to the sensor, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Diagevents
→ Sensor
→ 
→ Failure, an Outofspecication, a
Maintenancerequired or a Normalstate
→ 
The diagnostics on the sensor event is enabled.
→ .
English