296
Outputs – Parameter
Type 8098 FLOWave L
→
If the high value is equal to the low value, the digital output is deactivated.
→
→
→
→
The Newsettings are displayed.
→
18.5.4 Conguring a digital output as a pulse output
• either a number of pulses proportional to the measured volume (pulse/volume),
• volume/pulse),
• or a number of pulses proportional to the measured mass (pulse/mass),
• mass/pulse).
By default, the value of the parameter pulse/volume-
urement range. Observe the following rules to adapt the value of the parameter pulse/volume to
•
-
mitted immediately but are accumulated. The accumulated pulses are transmitted as a block
•
frequency that you have set.
•
→ Outputs Parameter Output1:analog or
Output3:analog Settings Currentsettings 20mAvalue or on the test
report that is delivered with the device.
• default number of pulses per volume unit:
•
English
To Next Page
Loading...
