Burkert FLOWave L - Message Calibration Result Out Of Range; Message Totalizer 1 Started; Totalizer 2 Started or Mass Totalizer 1 Started; Mass Totalizer 2 Started; Message Zero Calibration Cancelled, the Flow Rate Is Higher than 5 % of Full Scale; Messages Due To Calibration Or Simulation

331
Maintenance and troubleshooting
Type 8098 FLOWave L
24.9.23 Message "Totalizer1 started"/ "Totalizer2 started" or "Mass
totalizer1 started"/ "Mass totalizer2 started"
Message 
or

Symboldisplayedinthe
informationbar
-
Possiblecause / mass totalizer has been started by the user.
Whattodo? -
24.10 Messages due to calibration or simulation
24.10.1 Message "Calibration result out of range"
Message
Calibration result out of range
Symboldisplayedinthe
informationbar
(symbol changed)
Possiblecause
The calibration has failed. -
sible causes:
• An event such as Changeofliquid or Soundcond.outofrange has
been generated during the calibration.
• 
• 
or higher than 2.
Whattodo?
→ 
→ 
→ Do a new calibration.
24.10.2 Message "Zero calibration cancelled, the ow rate is higher
than 5% of full scale"
Message

Symboldisplayedinthe
informationbar
Possiblecause The calibration has failed because the
scale.
Whattodo?
→ 
→ Do a new calibration.
English