Burkert FLOWave L - Message Acoustic Transmission Factor Too Low; Message Density Too High

339
Maintenance and troubleshooting
Type 8098 FLOWave L
24.11.12 Message "Acoustic transmission factor too low"
Message
Acoustic transmission factor too low
Symboldisplayedinthe
informationbar
Possiblecause The value of the acoustic transmission factor is lower than the permitted

warning limits and the hysteresis of the acoustic transmission factor.
Whattodo? As soon as the value of the acoustic transmission factor returns to within
the permitted range, the error is automatically reset.
Message Acoustic transmission factor too low
Symboldisplayedinthe
informationbar
Possiblecause The value of the acoustic transmission factor is lower than the permitted

warning limits and the hysteresis of the acoustic transmission factor.
Whattodo? As soon as the value of the acoustic transmission factor returns to within
the permitted range, the warning is automatically reset.
24.11.13 Message "Density too high"
Message
Density too high
Symboldisplayedinthe
informationbar
Possiblecause 

hysteresis of the liquid density.
Whattodo? As soon as the value of the density returns to within the permitted range,
the error is automatically reset.
Message Density too high
Symboldisplayedinthe
informationbar
Possiblecause 

the hysteresis of the liquid density.
Whattodo? As soon as the value of the density returns to within the permitted range,
the warning is automatically reset.
English