80
How to do the settings
Type 8098 FLOWave L
10 HOW TO DO THE SETTINGS
10.1 Safety instructions
WARNING
Riskofinjuryduetonon-conformingadjustment.
Non-conforming adjustment could lead to injury and damage the device and its surroundings.
▶ The operators in charge of adjustment must have read and understood the contents of the Operating
Instructions.
▶ In particular, observe the safety recommendations and intended use.
▶
10.2 Available software to do the settings
The settings of the device can be done with:
•
• the Type 8920 Bürkert Communicator software, which must be installed on a PC.
The menu structure is the same in the display module and in the Bürkert Communicator software.
→
.
→
.
→
the Type 8920 Operating Instructions, available on the internet at country.burkert.com.
→ -
ating Instructions, available on the internet at country.burkert.com.
10.3 Connect the device to the Bürkert Communicator
software
To do the settings with the Type 8920 Bürkert Communicator software, do the following steps:
2. Download the latest version of the Type 8920 Bürkert Communicator software from country.burkert.com.
3. Install the Bürkert Communicator software on a PC. Obey the installation recommendations given in the
USB-büS interface set. During installation, the büS stick must not be inserted at the PC.
4. Screw the termination resistance into the Y plug or activate the device internal termination resistor (see
).
English
To Next Page
Loading...
