Burkert FLOWave L - Intended Use; Device with ATEX; Iecex Certification

8
Intended use
Type 8098FLOWaveL
2 INTENDED USE
Useofthedevicethatdoesnotcomplywiththeinstructionscouldpresentriskstopeople,nearby
installationsandtheenvironment.
TheType8098FLOWaveLowmeterusestheSurfaceAcousticWave(SAW)measurementprinciple
andisintendedtomeasuretheowrateofliquidsthathaveallthefollowingcharacteristics:
 clean liquids
 
 liquids that are free of air bubbles
 liquids that are free of gas bubbles
 liquids that are free of solids.
▶ 
origin of the bubbles (air intake, cavitation, degassing…).
▶ Use the device in compliance with the characteristics and the conditions of commissioning and use

▶ Protect the device against electromagnetic interference, ultraviolet rays and, when installed outdoors,

▶ Only operate a device in perfect working order.
▶ Properly transport, store, install and operate the device.
▶ Only use the device as intended.
2.1 Device with ATEX/IECEx certication
DANGER
Riskofexplosionintheeventofimproperuseofthedeviceinpotentiallyexplosiveareas.
▶ 
▶ -
ment is available at country.burkert.com

If unauthorized changes are made to the device, then 
English