Burkert FLOWave L - Setting the Measurement Mode of Liquid Density

200
SAW sensor – Parameter
Type 8098 FLOWave L
→ Stand.meas.values
→ Density
→ Limits
→ Resettodefault
→ 
The limit values and the hysteresis value are reset.
→ 
15.9.9 Setting the measurement mode of liquid density
Density mode can be selected through the following values:
• 
• 
• Constant (value set to a constant value)
• r
• r
2

When option Density is ordered, default density mode will be Measured.
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Density
→ Mode The Currentsettings are displayed.
→  Measured, Water, Constant, Linear, Quadratic
→  Constant, Linear, Quadratic mode), then set the values
English