Burkert FLOWave L - Message Concentration 1 Too High; Concentration 2 Too High; Message Density Too Low

340
Maintenance and troubleshooting
Type 8098 FLOWave L
24.11.14 Message "Density too low"
Message
Density too low
Symboldisplayedinthe
informationbar
Possiblecause The value of the density is lower than the permitted minimum error value set
-
teresis of the liquid density.
Whattodo? As soon as the value of the density returns to within the permitted range,
the error is automatically reset.
Message Density too low
Symboldisplayedinthe
informationbar
Possiblecause The value of the density is lower than the permitted minimum warning value

hysteresis of the liquid density.
Whattodo? As soon as the value of the density returns to within the permitted range,
the warning is automatically reset.
24.11.15 Message "Concentration1 too high"/ "Concentration2 too high"
Message

Symboldisplayedinthe
informationbar
Possiblecause 

and the hysteresis of the liquid concentration.
Whattodo? As soon as the value of the liquid concentration returns to within the per-
mitted range, the error is automatically reset.
Message 
Symboldisplayedinthe
informationbar
Possiblecause 

limits and the hysteresis of the liquid concentration.
Whattodo? As soon as the value of the liquid concentration returns to within the per-
mitted range, the warning is automatically reset.
English