Burkert FLOWave L - Message Acoustic Transmission Factor Too High; Message Df Too Low

338
Maintenance and troubleshooting
Type 8098 FLOWave L
24.11.10 Message "DF too low"
Message
DF too low
Symboldisplayedinthe
informationbar
Possiblecause The value of the DF is lower than the permitted minimum error value set in
-
.
Whattodo? As soon as the value of the DF returns to within the permitted range, the
error is automatically reset.
Message DF too low
Symboldisplayedinthe
informationbar
Possiblecause The value of the DF is lower than the permitted minimum warning value set
-
.
Whattodo? As soon as the value of the DF returns to within the permitted range, the
warning is automatically reset.
24.11.11 Message "Acoustic transmission factor too high"
Message
Acoustic transmission factor too high
Symboldisplayedinthe
informationbar
Possiblecause The value of the acoustic transmission factor is higher than the permitted

warning limits and the hysteresis of the acoustic transmission factor.
Whattodo? As soon as the value of the acoustic transmission factor returns to within
the permitted range, the error is automatically reset.
Message Acoustic transmission factor too high
Symboldisplayedinthe
informationbar
Possiblecause The value of the acoustic transmission factor is higher than the permitted

warning limits and the hysteresis of the acoustic transmission factor.
Whattodo? As soon as the value of the acoustic transmission factor returns to within
the permitted range, the warning is automatically reset.
English