Burkert FLOWave L - Reading out the Calibration Date at the Manufacturer

260
SAW sensor – Maintenance
Type 8098 FLOWave L
• 
the menu Deviceverication on the display and in the report. Refer to .
 
 Current measured value of the Parameter in the
menu Deviceverication on the display and in the
report
DF DF
Acoustictransmissionfactor Acoustictransmissionfactor
Amplitudes SAWsignal
SignalWGxyz
Timesofight A0
WGx
4. Evaluate the deviations of all parameters:
• If the deviations of all parameters are less than the values that are given in , then the sensor
operates correctly.
• , then the sensor can
possibly be defect. Contact Bürkert.
 
Parameters Deviation
DF 
Acoustictransmissionfactor 
Amplitudes SAWsignal 
SignalWGxyz 
Timesofight A0 
WGx 
17.3.6 Reading out the calibration date at the manufacturer
To read out the calibration date of the device at the manufacturer, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Deviceverication
→ Factorycalibration Date
→ 
English