194
SAW sensor – Parameter
Type 8098 FLOWave L
15.9 Setting the parameters of the liquid density
15.9.1 Giving a user dened name to the measured liquid density
Outputs menu).
By default, the name associated to the measured liquid density is Density.
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Density
→ Valuename .
→
characters.
→ OK
→
The name is changed.
15.9.2 Activating the damping of the liquid density values and
choosing a predened damping level
• on the display,
• on the outputs. The damping of the liquid density comes in addition to the damping set for each analog
),
•
The damping is not applied to the new measured value, if the 2 following conditions are met:
• a Low, Medium or High damping level is active,
•
By default, the measured liquid density values are damped with the level Medium.
→ Low, Medium or High, you can set your own
damping parameters. See .
English
To Next Page
Loading...
