Burkert FLOWave L - Activating the Damping of the Mass Flow Rate Values and Choosing a Predefined Damping Level; Giving a User Defined Name to the Measured Mass Flow Rate; Setting The Parameters Of The Mass Flow Rate

162
SAW sensor – Parameter
Type 8098 FLOWave L
15.5 Setting the parameters of the mass ow rate
15.5.1 Giving a user dened name to the measured mass ow rate

Outputs menu).
Massow.

→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Massow
→ Valuename .
→   
characters.
→  OK
→ 
The name is changed.
15.5.2 Activating the damping of the mass ow rate values and
choosing a predened damping level

• on the display,
• on the totalizers,
• 
rate.
The damping is not applied to the new measured value, if the 2 following conditions are met:
• a Low, Medium or High damping level is active,
• 

Medium.
The Low damping level or no damping at all (None) are suited for applications/processes that need fast
response times.
The Medium damping level or the High
English