Burkert FLOWave L - Changing the Error Limits, the Warning Limits and the Hysteresis of the Mass Flow Rate; Resetting the Default Values of the Error Limits, the Warning Limits and the Hysteresis of the Mass Flow Rate

169
SAW sensor – Parameter
Type 8098 FLOWave L
15.5.7 Changing the error limits, the warning limits and the hysteresis
of the mass ow rate

→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values Massow
→ Limits
→ Settings The Currentsettings are displayed
→  
→  
→  
→  
→   The Newsettings are displayed.
→ 
The limit values and the hysteresis value are changed.
15.5.8 Resetting the default values of the error limits, the warning
limits and the hysteresis of the mass ow rate

the DN of the measurement tube:
• 
• low error value: opposite value of the high error value,
• 
• low warning value: opposite value of the high warning value,
• 

the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
English