Burkert FLOWave L - Calibrating The Offset Value Of The Acoustic Transmission Factor; Setting The Offset Value Of The Acoustic Transmission Factor

279
SAW sensor – Maintenance
Type 8098 FLOWave L
17.23 Setting the oset value of the acoustic transmission
factor

.

→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Add.meas.values
→ Acoustictransmissionfactor
→ Oset
→ Entervalue
→  
→ 

17.24 Calibrating the oset value of the acoustic
transmission factor
→ 
→ In order that the calibration result is correct, make sure the following conditions are met during the
teach-in procedure:
• The liquid temperature is stable.
• 
of bubbles.
During the calibration:
• The device status indicator is orange, if the operating mode of the device status indicator is set

).
• 

.
English