Burkert FLOWave L - Page 280

280
SAW sensor – Maintenance
Type 8098 FLOWave L

→ 
→ Charge the pipe. To avoid bubbles and air in the pipe, make sure it is full of liquid.
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Add.meas.values
→ Acoustictransmissionfactor
→ Oset
→ Teach-inbyreference The Currentsettings are displayed.
→ 
→   The
Newsettings are displayed.
→ 


simulation.
→ 
English