Burkert FLOWave L - Disabling The Diagnostics On A Special Event Occurring On The Sensor; Enabling The Diagnostics For Special Events Occurring On The Electronics

239
SAW sensor – Parameter
Type 8098 FLOWave L
15.14.4 Enabling the diagnostics for special events occurring on the
electronics
By default, all the diagnostics related to the electronics are disabled.
To enable the diagnostics related to the electronics, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Diagevents
→ Electronic
→ 
→ Failure, an Outofspecication,
a Maintenancerequired or a Normalstate
→ 
The diagnostics on the electronics event is enabled.
→ .
15.14.5 Disabling the diagnostics on a special event occurring on the
sensor
By default, all the diagnostics related to special events occurring on the sensor are disabled.
If a special event occurring on the sensor is enabled, do the following to disable the event:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Diagevents
→ Sensor
→ 
→ None
→ 
The diagnostics on the special event is disabled.
English