Burkert FLOWave L - Message Liquid Out Of Range; Message Not Totally Filled; Message Unstable Flow Rate

342
Maintenance and troubleshooting
Type 8098 FLOWave L
24.12.3 Message "Not totally lled"
Message

Symboldisplayedinthe
informationbar
Depends on the device status the event is associated to.
Possiblecause
The calibration has failed. The calibration has failed because of one of the
possible causes:
• The sensor may be broken (valid for product variants with DN08).
• 
the liquid and measurement is not possible.
-
toring special events that occur in the process, on the sensor or on the
electronics.
Whattodo?
→ 

→ If the message Nosignalsfrominterdigitaltransducer is generated
simutaneously, then send the product back to Bürkert.
→ If the message Nottotallylled remains, then send the product back to
Bürkert.
24.12.4 Message "Liquid out of range"
Message

Symboldisplayedinthe
informationbar
Depends on the device status the event is associated to.
Possiblecause
The speed of sound in the liquid is out of range.
-
toring special events that occur in the process, on the sensor or on the
electronics.
The density in the liquid is out of range.
Whattodo?
→ 
.
24.12.5 Message "Unstable ow rate"
Message

Symboldisplayedinthe
informationbar
Depends on the device status the event is associated to.
Possiblecause
-
ments is too high.
-
toring special events that occur in the process, on the sensor or on the
electronics.
Whattodo?
→ 
pumps and process valves, is correct.
English