Burkert FLOWave L - Changing the Error Limits, the Warning Limits and the Hysteresis of the Liquid Temperature; Resetting the Default Values of the Error Limits, the Warning Limits and the Hysteresis of the Liquid Temperature

178
SAW sensor – Parameter
Type 8098 FLOWave L
15.6.7 Changing the error limits, the warning limits and the hysteresis
of the liquid temperature
To change the error limits, the warning limits and the hysteresis of the liquid temperature, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Temperature
→ Limits
→ Settings The Currentsettings are displayed
→  
→  
→  
→  
→   The Newsettings are displayed.
→ 
The limit values and the hysteresis value are changed.
15.6.8 Resetting the default values of the error limits, the warning limits
and the hysteresis of the liquid temperature
The default values of the error limits, the warning limits and the hysteresis of the liquid temperature are the
following:
• 
• 
• 
• 
• 
To reset the default values of the error limits, the warning limits and the hysteresis of the liquid temperature,
do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
English