Burkert FLOWave L - Activating a User-Defined Damping of the Liquid Temperature Values

175
SAW sensor – Parameter
Type 8098 FLOWave L
15.6.3 Activating a user-dened damping of the liquid temperature
values

• on the display,
• on the outputs. The damping of the liquid temperature comes in addition to the damping set for each
).
By default, the measured liquid temperature values are not damped.

→ Low, Medium or High.
→ Or you can set your own damping parameters with the Special damping.
With the Special damping, you can set 2 parameters:
• Responsetime in seconds,
• the Jumpthreshold
the set temperature value, no damping is applied to the second measured value.
To set your own damping parameters of the measured liquid temperature values, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Temperature
→ Damping The Currentsettings are displayed
→ Special
→ Responsetime
→ Jumpthreshold is enabled or disabled
→ Jumpthreshold is enabled, set the value.
→ The Newsettings are displayed 
The special damping of the liquid temperature values is active.
English