Burkert FLOWave L - Deactivating the Monitoring of the Liquid Temperature

177
SAW sensor – Parameter
Type 8098 FLOWave L
→ Parameter view.
→ Stand.meas.values
→ Temperature
→ Limits
→ Active
→ Yes.
→ 
The monitoring of the liquid temperature is active and the device status will change depending on the
limits that have been set.
→ 
.
→ 
.
→ To enable the monitoring, i.e. to be informed when the value of the liquid temperature is outside the
.
15.6.6 Deactivating the monitoring of the liquid temperature
By default, the liquid temperature values are not monitored. If the monitoring of the liquid temperature is
active, do the following to deactivate it:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values Temperature
→ Limits
→ Active
→ No
→ 
The monitoring of the liquid temperature is inactive.
English