Burkert FLOWave L - Resetting the Default Values of the Error Limits, the Warning Limits and the Hysteresis of the Differentiation Factor

222
SAW sensor – Parameter
Type 8098 FLOWave L
15.12.9 Resetting the default values of the error limits, the warning
limits and the hysteresis of the dierentiation factor
The default values of the error limits, the warning limits and the hysteresis of the DF are the following:
• 
• 
• 
• 
• 
To reset the default values of the error limits, the warning limits and the hysteresis of the DF, do the
following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values DF
→ Limits
→ Resettodefault
→ 
The limit values and the hysteresis value are reset.
→ 
English