Burkert FLOWave L - Message Df Too High; Message Fluid Velocity Too Low

337
Maintenance and troubleshooting
Type 8098 FLOWave L
24.11.8 Message "Fluid velocity too low"
Message
Fluid velocity too low
Symboldisplayedinthe
informationbar
Possiblecause The value of the liquid velocity is lower than the permitted minimum error

the hysteresis of the liquid velocity.
Whattodo? As soon as the value of the liquid velocity returns to within the permitted
range, the error is automatically reset.
Message Fluid velocity too low
Symboldisplayedinthe
informationbar
Possiblecause The value of the liquid velocity is lower than the permitted minimum warning

the hysteresis of the liquid velocity.
Whattodo? As soon as the value of the liquid velocity returns to within the permitted
range, the warning is automatically reset.
24.11.9 Message "DF too high"
Message
DF too high
Symboldisplayedinthe
informationbar
Possiblecause 
-
.
Whattodo? As soon as the value of the DF returns to within the permitted range, the
error is automatically reset.
Message DF too high
Symboldisplayedinthe
informationbar
Possiblecause 
-
.
Whattodo? As soon as the value of the DF returns to within the permitted range, the
warning is automatically reset.
English