Burkert FLOWave L - Knowing the Status of the Ethernet Network (Device Variant with Two 4-Pin M12 Female Connectors - Ethernet Device Variant)

69
Electrical installation
Type 8098 FLOWave L
8.16 Knowing the status of the Ethernet network (device
variant with two 4-pin M12 female connectors –
Ethernet device variant)
-
cation module in the transmitter housing.
→ 
8.9.

(Ethernet Port Switch):





X1 X2

(Ethernet Port Switch):


 
DescriptionoftheLEDs:
 
LEDstatus Connectionstatus Whattodo?
RUNLED(green) ErrorLED(yellow)
ON OFF Connection active. -
OFF ON Connection not active. Check cables
 
LEDstatus Connectionstatus Whattodo?
Link/Act
LED
(green)
ON -
tocol layer EtherNet/IP has been established. Data
is being transmitted.
-


-
OFF No connection to the network is available. Check cables
LinkLED
(yellow)
ON Connection to the network is available. -
OFF No connection to the network is available. Check cables
English