Burkert FLOWave L - Activating The Diagnostics Function

119
General settings – Parameter
Type 8098 FLOWave L
→  
→   The new date and time settings are displayed.
→  
→ Quickstart settings or 
12.10 Activating the diagnostics function
WARNING
Riskofinjuryduetonon-conformingadjustment.
Non-conforming adjustment could lead to injuries and damage the device and its surroundings.
▶ The operators in charge of adjustment must have read and understood the contents of the Operating
Instructions.
▶ In particular, observe the safety recommendations and intended use.
▶ 
By default, all the diagnostics events related to the process, the electronics or the sensor, the messages

the device and on büS are disabled.
To activate the diagnostics, do the following:
→ .
→ ,

→ Go to the CONFIGURATION view.
→ Generalsettings
→ Parameter view.
→ Diagnostics Read the displayed message
→ Active
→ 
The needed diagnostics are active.
English