Burkert FLOWave L - Choosing The Counting Direction Of Each Mass Totalizer

209
SAW sensor – Parameter
Type 8098 FLOWave L
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Masstotalizer1 or Masstotalizer2
→ Valuename .
→   
characters.
→  OK
→ 
The name is changed.
15.11.2 Choosing the counting direction of each mass totalizer
By default, the counting direction of both mass totalizers is Positiveonly.
The possible counting directions are:
• Positiveonly
i.e. in the same direction as the arrow located on the front of the device.
• Negativeonly
i.e. in the direction opposite to the direction of the arrow located on the front of the device.
• Both

To change the counting direction of each mass totalizer, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Masstotalizer1 or Masstotalizer2
→ Countingdirection .
→ 
→ 
The counting direction is changed.
English