Burkert FLOWave L - Message Calibration Cancelled; Message Calibration Cancelled, The Flow Rate Is Less Than 5 % Of The Full; Message Resulting K Factor Is Less Than 0.8 Or Higher Than 1.2; Message Resulting Offset Is Higher Than 10 °C, 18 °F

332
Maintenance and troubleshooting
Type 8098 FLOWave L
24.10.3 Message "Calibration cancelled"
Message
Calibration cancelled
Symboldisplayedinthe
informationbar
Possiblecause 
time of 30 seconds has elapsed.
Whattodo?
→ Do a new calibration and observe the given instructions.
24.10.4 Message "Calibration cancelled, the ow rate is less than 5%
of the full scale"
Message

Symboldisplayedinthe
informationbar
Possiblecause The calibration has failed because 
scale.
Whattodo?
→ 
→ Do a new calibration.
24.10.5 Message "Resulting K factor is less than 0.8 or higher than
1.2"
Message

Symboldisplayedinthe
informationbar
Possiblecause When calibrating the K factor by using a teach-in procedure depending
-

Whattodo?
→ Do a new calibration.
→ Enter a correct reference value.
24.10.6 Message "Resulting oset is higher than 10°C, 18°F"
Message

Symboldisplayedinthe
informationbar
Possiblecause 

Whattodo?
→ Do a new calibration.
→ Enter a correct reference value.
English