Burkert FLOWave L - Additional Documentation; Changing the Position of the Transmitter on the Sensor; Preparing the Device before Installation into the Pipe

39
Installation in the pipe
Type 8098 FLOWave L
CAUTION
Riskofinjuryduetoaheavydevice.
A heavy device can fall down during transport or during installation and cause injuries.
▶ Transport, install and dismantle a heavy device with the help of another person.
▶ Use appropriate tools.
NOTICE
Thedevicewillbedamagedifyouuseatooltoturntheblindcoverorthedisplaymodule.
▶ Do not use a tool to turn the blind cover or the display module.
Riskoffailureorriskofacceleratedageingofelectricalcomponents.
▶ Observe the dependence between liquid temperature and ambient temperature (see  and
).
7.2 Additional documentation
→ 
country.burkert.com.
7.3 Preparing the device before installation into the pipe
.
Before installing the device into the pipe, you may:
• .
• .
7.3.1 Changing the position of the transmitter on the sensor
These instructions are valid for all the device variants.
.
English