Burkert FLOWave L - Activating the Damping of the Values of the Acoustic Transmission Factor and Choosing a Predefined Damping Level

227
SAW sensor – Parameter
Type 8098 FLOWave L
→ Add.meas.values
→ Acoustictransmissionfactor
→ Valuename .
→   
characters.
→  OK
→ 
The name is changed.
15.13.3 Activating the damping of the values of the acoustic
transmission factor and choosing a predened damping level
-
mission factor:
• on the display,
• on the totalizers,
• on the outputs. The damping set for an analog output comes in addition to the damping of the acoustic
transmission factor.
The damping is not applied to the new measured value, if the 2 following conditions are met:
• a Low, Medium or High damping level is active,
• 
By default, the values of the acoustic transmission factor are damped with the level None.
The Low damping level or no damping at all (None) are suited for applications/processes that need fast
response times.
The Medium damping level or the High damping level are suited if the values of the acoustic transmission
factor change slowly.
→ Low, Medium or High, you can set your own
.
English