Burkert FLOWave L - Page 228

228
SAW sensor – Parameter
Type 8098 FLOWave L
None damping: all

measured values are
transmitted
Low damping Medium damping High damping
Chosen damping level is applied

 
 

Dampinglevel Responsetime
None 
 
 
 
Special
Responsetime

→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values
→ Acoustictransmissionfactor
→ Damping The Currentsettings are displayed
→ Low, Medium and High The Newsettings are
displayed.
→ 

is chosen.
English