Burkert FLOWave L - Resetting the Default Values of the Error Limits, the Warning Limits and the Hysteresis of the Volume Flow Rate

158
SAW sensor – Parameter
Type 8098 FLOWave L
15.4.8 Resetting the default values of the error limits, the warning
limits and the hysteresis of the volume ow rate

on the DN of the measurement tube:
• 
• low error value: opposite value of the high error value,
• 
• low warning value: opposite value of the high warning value,
• 

do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Volumeow
→ Limits
→ Resettodefault
→ 
The limit values and the hysteresis value are reset.
→ 
English