Burkert FLOWave L - Setting The Offset Value Of The Flow Zero Point

263
SAW sensor – Maintenance
Type 8098 FLOWave L
→ Stand.meas.values
→ Flowrate
→ Oset
→ Zeroowosetbyteach-in The Currentsettings are displayed.
→  
Newsettings are displayed.
→ 


simulation.
→ 
17.6 Setting the oset value of the ow zero point

.

→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Stand.meas.values
→ Flowrate
→ Oset
→ Entervalue
→  

→ 

English