Burkert FLOWave L - Message Measure Board Is In Boot Starter Mode, No Firmware Found N°1; Message Measured Values Cannot Be Used; Message The Measurement Board Bootloader Operation Failed N° 1; Message Communication between Transmitter PCB and Measurement PCB Has Been Interrupted N°X

329
Maintenance and troubleshooting
Type 8098 FLOWave L
24.9.15 Message "Measure board is in boot starter mode, no rmware
found n°1"
Message

Symboldisplayedinthe
informationbar
Possiblecause 
Whattodo?
→ Start the device again.
→ If the error is still there, send the device back to Bürkert.
24.9.16 Message "Measured values cannot be used"
Message

Symboldisplayedinthe
informationbar
-
Possiblecause 
there are too many bubbles in the liquid or the sensor tube is not completely

Whattodo?
→ 
24.9.17 Message "Communication between transmitter PCB and
measurement PCB has been interrupted n°x"
Message Communication between transmitter PCB and measurement PCB has been

Symboldisplayedinthe
informationbar
Possiblecause There is no communication between the sensor and the transmitter.
Whattodo?
→ 

position of the transmitter on the sensor.
24.9.18 Message "The measurement board bootloader operation
failed n° 1"
Message

Symboldisplayedinthe
informationbar
Possiblecause 
Whattodo?
→ Send the device back to Bürkert.
English