Burkert FLOWave L - Activating The Compensation For A Liquid With A Constant Viscosity; Activating The Viscosity Compensation For Water-Like Liquids

242
SAW sensor – Parameter
Type 8098 FLOWave L
15.15.1 Activating the viscosity compensation for water-like liquids
To activate the viscosity compensation of water-like liquids, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Viscositycompensation
→ Settings The current settings are displayed.
→  Water
→  
The viscosity compensation for a water-like liquid is active.
15.15.2 Activating the compensation for a liquid with a constant
viscosity
The kinematic viscosity of a liquid can be constant either because the temperature of the liquid is constant

To activate the compensation for a liquid with a constant viscosity, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Viscositycompensation
→ Settings The current settings are displayed.
→ 
→ Constant 
→  
2
/s). You must enter a pos-

2
/s, enter

→ The Newsettings are displayed.
→ 
The compensation for a liquid with a constant viscosity is active.
English