Burkert FLOWave L - Deactivating the Monitoring of the Liquid Velocity

191
SAW sensor – Parameter
Type 8098 FLOWave L
→ Limits
→ Active
→ Yes.
→ 
The monitoring of the liquid velocity is active and the device status will change depending on the limits
that have been set.
→ 
.
→ 
.
→ To enable the monitoring, i.e. to be informed when the value of the liquid velocity is outside the normal
.
15.8.6 Deactivating the monitoring of the liquid velocity
By default, the liquid velocity values are not monitored.
But if the monitoring of the liquid velocity is active, do the following to deactivate it:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Liquidvelocity Limits
→ Active
→ No.
→ 
The monitoring of the liquid velocity is inactive.
English