Burkert FLOWave L - Calibrating The Liquid Density By Using A Teach-In Procedure Depending On Density; Setting The Offset Value Of The Liquid Concentration

276
SAW sensor – Maintenance
Type 8098 FLOWave L
→ Slope
→ Entervalue
→  
→ 
The slope value of the liquid density is set.
17.19 Calibrating the liquid density by using a teach-in
procedure depending on density
To calibrate the liquid density, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ MAINTENANCE view.
→ Calibration
→ Stand.meas.values
→ Density
→ Teach-inbydensity The current dacoecient is displayed.
→ 
→   The Newsettings are displayed.
→ 

→ 
17.20 Setting the oset value of the liquid concentration

.

→ Go to the CONFIGURATION view.
→ SAWsensor
English