Burkert FLOWave L - Changing The Refresh Time; Setting The Refresh Time; Use Case Of The Refresh Time

247
SAW sensor – Parameter
Type 8098 FLOWave L
15.16 Setting the refresh time
15.16.1 Use case of the refresh time
The refresh time is the minimum time needed to update a measurement value. The refresh time has no

The refresh time of the temperature values is a constant but the refresh time of the other measurement
values can be adapted to the process:
• 
very short dosings.
• 
15.16.2 Changing the refresh time
3 refresh times are available:
• a Long
• a Short
• a Veryshort
If the very short refresh time is set:
• The diagnostics event Nottotallylled is not available.
• 
• 

received pulse:
• Veryshort,
• Short,
• Long.
To change the refresh time, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Refreshtime .
→ 
→ 
The refresh time is changed.
English