Burkert FLOWave L - Message Cyclic Data Transfer Has Been Slower Than Configured Timeout; Message Master Tried To Plug Wrong Module Or Submodule; Message No Or Incorrect Mapping File Available; Message Please Select A Protocol And Restart The Device

346
Maintenance and troubleshooting
Type 8098 FLOWave L
24.13.2 Message "Cyclic data transfer has been slower than
congured timeout"
Message

Symboldisplayedinthe
informationbar
Possiblecause The parameter CommunicationTimeout is not correctly parametered.
(timeout should be written without upper case t in the menu point)
Whattodo?
→ -
munication timeout and enabling it.
24.13.3 Message "No or incorrect mapping le available"
Message

Symboldisplayedinthe
informationbar
Possiblecause 
Whattodo?
→ Contact the Bürkert service.
24.13.4 Message "Please select a protocol and restart the device"
Message
Please select a protocol and restart the device
Symboldisplayedinthe
informationbar
Possiblecause No valid protocol has been set on the device.
Whattodo?
→ If the device is connected to an industrial network, set the correct pro-
.
→ Restart the device.
24.13.5 Message "Master tried to plug wrong module or submodule"
Message

Symboldisplayedinthe
informationbar
Possiblecause 
device.
Whattodo?
→ 
→ 
English