181
SAW sensor – Parameter
Type 8098 FLOWave L
15.7.3 Activating the damping of the liquid concentration values and
choosing a predened damping level
• on the display,
• on the outputs. The damping of the liquid concentration comes in addition to the damping set for each
).
The damping is not applied to the new measured value, if the 2 following conditions are met:
• a Low, Medium or High damping level is active,
•
By default, the measured liquid concentration values are not damped.
→ Low, Medium or High, you can set your own
damping parameters. See .
None damping: all
measured values are
transmitted
Low damping Medium damping High damping
Chosen damping level is applied
Damping level Response time
None
Special
Responsetime
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values
English
To Next Page
Loading...
