Burkert FLOWave L - Reading out the Maximum Number of Transmit Errors Since the Last Power-Up of the Device; Reading out Whether the Measured Process Data (PDO, Process Data Object) Is Sent on Büs or on the Canopen Fieldbus; Resetting the 2 Maximum Error Counters

133
General settings – Diagnostics
Type 8098 FLOWave L
→ Transmiterrors
→ 
13.3.4 Reading out the maximum number of transmit errors since the
last power-up of the device

→ Go to the CONFIGURATION view.
→ Generalsettings
→ Parameter view.
→ DIAGNOSTICS view.
→ büSstatus Transmiterrorsmax.
→ 
13.3.5 Resetting the 2 maximum error counters

→ Go to the CONFIGURATION view.
→ Generalsettings
→ Parameter view.
→ DIAGNOSTICS view.
→ büSstatus
→ Reseterrorcounter
→ 

13.3.6 Reading out whether the measured process data (PDO,
process data object) is sent on büS or on the CANopen
eldbus
To read out whether the measured process data (PDO, process data object) is sent on büS or on the

→ Go to the CONFIGURATION view.
→ Generalsettings
→ Parameter view.
English