210
SAW sensor – Parameter
Type 8098 FLOWave L
15.11.3 Activating the monitoring of each mass totalizer value
A monitored value can be:
• in the normal operating range.
• in the warning range,
• in the error range.
You can set 4 limit values: 2 error limits and 2 warning limits.
→ -
teresis of each mass totalizer.
in
and if the monitored value increases or decreases.
By default, the monitoring of the mass totalizers and the diagnostics are all disabled.
To activate the monitoring of each mass totalizer, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Stand.meas.values
→ Masstotalizer1 or Masstotalizer2
→ Limits
→ Active
→ Yes
→
The monitoring of the mass totalizer is active and the device status will change depending on the limits
that have been set.
→
.
→
.
→ To enable the monitoring, i.e. to be informed when the value of a mass totalizer is outside the normal
.
English
To Next Page
Loading...
