Burkert FLOWave L - Monitoring The Device Supply Voltage Or The Device Temperature; Stop Sending the Measured Process Data (Pdos) to Büs or to the Canopen Fieldbus

115
General settings – Parameter
Type 8098 FLOWave L
12.6.7 Stop sending the measured process data (PDOs) to büS or to
the CANopen eldbus
Bus mode is set to büS or to CANopen

→ Go to the CONFIGURATION view.
→ Generalsettings
→ Parameter view.
→ büS Advanced
→ Bus mode
→ Standalone
→ 
→ Restart the device.
The CANopenstatus is set to Pre-op
The communication with the software Bürkert Communicator is still operational.
→ .
12.7 Monitoring the device supply voltage or the device
temperature
The supply voltage of the device and the internal temperature of the device are monitored.
A monitored value can be:
• in the normal operating range,
• in the warning range,
• in the error range.
4 limit values are set, 2 error limits and 2 warning limits. The error limits can only be read but the warning
limits can be adjusted.

from the normal range into the warning range). The reaction time depends on the hysteresis value and on
whether the monitored value increases or decreases.
English