Burkert FLOWave L - Activating the Damping of the Differentiation Factor Values and Choosing a Predefined Damping Level

217
SAW sensor – Parameter
Type 8098 FLOWave L
15.12.3 Activating the damping of the dierentiation factor values and
choosing a predened damping level

• on the display,
• on the totalizers,
• on the outputs. The damping set for an analog output comes in addition to the damping of the DF.
The damping is not applied to the new measured value, if the 2 following conditions are met:
• a Low, Medium or High damping level is active,
• 
when changing the liquid in the pipe).
By default, the DF values are damped with the level None.
The Low damping level or no damping at all (None) are suited for applications/processes that need fast
response times.
The Medium damping level or the High damping level are suited if the DF values change slowly.
→ Low, Medium or High, you can set your own
.
None damping: all

measured values are
transmitted
Low damping Medium damping High damping
Chosen damping level is applied

 
 
Dampinglevel Responsetime
None 
 
 
 
Special
Responsetime
English