Burkert FLOWave L - Wiring the Device through the M20 X1.5 Cable Glands in Nickel Plated Brass (Device Variant with Cable Glands)

63
Electrical installation
Type 8098 FLOWave L
8.11 Wiring the device through the M20x1.5 cable glands in
nickel plated brass (device variant with cable glands)
Put only one cable in each cable gland.
→ 
.
→ To open the front of the transmitter, follow the
8.9.
 
screws of the functional earth plate.
2 screws
2. 
3. 
4. 
20 mm
100 mm ±5
8 mm
 
 Remove the blind plug of the cable gland and
store the blind plug in a safe and clean place.
 
the cable through the cable gland as shown in

8. 

9. 
→ vertically put a screwdriver between the two
seals,
→ lift the inner seal and remove it.
→ Put the cable through the cable gland.
→ 

English