Burkert FLOWave L - Reading Out The Low Warning Limit For The Voltage Of The Internal Battery; Start-Up - Doing The Basic Settings

118
General settings – Parameter
Type 8098 FLOWave L
→ Hysteresis
→ 
12.8 Reading out the low warning limit for the voltage of
the internal battery

not powered.
To read out the value of the low warning limit, do the following:
→ Go to the CONFIGURATION view.
→ Generalsettings
→ Alarmlimits
→ Warningbatteryvoltagelow
→ 
12.9 Start-up – Doing the basic settings
The Quickstart
To change the Quickstart settings, do the following:
→ Go to the CONFIGURATION view.
→ Generalsettings
→ Parameter view.
→ Quickstart
→ Display
→  
chosen language.
→ 
→ On) or not (O)
for the display of the time.
→  
→  
→  
English