Burkert FLOWave L - Activating The Temperature Compensation For Water

224
SAW sensor – Parameter
Type 8098 FLOWave L
→  


→ 
→  
2

→ 
→  
3

→ 
→  
4

→ 
→  


→  The new settings are displayed.
→ 
The temperature compensation for a liquid other than water is active.
15.12.12 Activating the temperature compensation for water
To activate the temperature compensation for water, do the following:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Add.meas.values
→ DF
→ Compensation The current settings are displayed.
→ 
→ Water
→  The new settings are displayed.
→ 
The temperature compensation for water is active.
English