Burkert FLOWave L - Disabling The Diagnostics On A Special Event Occurring On The Electronics; Disabling The Diagnostics On A Special Event Related To The Process

238
SAW sensor – Parameter
Type 8098 FLOWave L
15.14.2 Disabling the diagnostics on a special event related to the
process
By default, all the diagnostics related to the process are disabled.
If a special event related to the process is enabled, do the following to disable the event:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Diagevents
→ Process
→ 
→ None
→ 
The diagnostics on the special event is disabled.
15.14.3 Disabling the diagnostics on a special event occurring on the
electronics
By default, all the diagnostics related to special events occurring on the electronics are disabled.
If a special event occurring on the electronics is enabled, do the following to disable the event:
→ Go to the CONFIGURATION view.
→ SAWsensor
→ Parameter view.
→ Diagevents
→ Electronic
→ 
→ None
→ 
The diagnostics on the special event is disabled.
English